GBC eWire Service Manual page 313

12) Twist and pull the element off the sheets taking care not to tear them.
Take the first sheet in the stack (the one that was touching the tray)
and place position it on the Punched Hole Position Check Tool found
on the inside of the Feeder Drawer or in the following pages. Remove
a sheet from the unfinished book. Looking at the side of a sheet that
was facing the tray, the center of the small hole created by the
element due to the missing pin should be in line with the centers of
the punch holes. The distance between the center of the small hole
created by the element and the punched holes on either side should
be equal.
13) Take the first sheet in the stack (the one that was touching the tray)
and place it on the Punched Hole Position Check Tool found on the
inside of the Feeder Door. The side of the sheet that was facing the
tray should be face up. You should see a small hole or an indent in
the positions of the removed pins.
14) Using the edge of the Punched Hole Position Check Tool or a
straight-edge, draw a line from the center of the small holes or
indents to the center of the punched holes on either side (try to keep
the line parallel with the edge of the sheet).
15) Draw a line from the center of the small holes or indents to the edge
of the sheet (try to keep the line perpendicular to the edge of the
sheet).
GBC eWire
16) Place the sheet so that the small hole or indent matches the below
pictures. The edge of the sheet should be collinear with the horizontal
black line and circular or square markings should match up with the
punched holes. Following the 1mm markings on the tool, the optimal
position for the small holes are indicated by the wider black marks.
NOTE: When changing the DESKEW ADJUST and ALIGNMENT
settings these values correspond to all element sizes. When
changing the DEFLECTOR setting this value only corresponds to
the currently loaded element size.
17) Check and correct the sheet skew. Do GP 6.3.18 to access the
DESKEW ADJUST setting.
If the small hole on the right is too close to the edge and the small
hole on the left is too far away decrease this value by 1.
If the small hole on the right is too far away from the edge and the
small hole on the left is too close increase this value by 1.
Repeat Step 5-6 and 12-16.
Both small holes are the same distance from the edge of the
sheet
Yes- Go to Step 18
No- Repeat this step
01/26/2018
4-197
Repairs/Adjustments