GBC eWire Service Manual page 280

6. Remove the old interlock by depressing the tabs on the interlock and
removing it from the cutout in the bracket.
Repairs/Adjustments
Installation Procedure
1. Install the new Interlock by pressing it into the Interlock Bracket until
the tabs snap into place.
2. Reattach the wires, being careful to maintain the correct wire
orientation.
3. Position the interlock switch on the Frame and secure it using the M4
Screws and Washers (2).
4. If necessary, adjust the Interlock Switch position so that the Interlock
Tabs
Flag is centered in the Interlock Switch.
5. Connect the Power Cord
6. Turn power ON to eWire.
01/26/2018
4-164
GBC eWire