Adj 1.10 Element Tip Height Adjustment - GBC eWire Service Manual

Adjustment Procedure
1) Fine adjustment to the Holder Vertical or Horizontal position can be
made by adjusting the setscrew(s) on the Holder yoke. Note that
there is a setscrew for both vertical and horizontal adjustment.
2) In some cases, the Holder may need to be adjusted slightly past
horizontal to achieve better closing roundness.
3) Repeat this process until the proper positions are reached for both
vertical and horizontal Holder positions.
4) Return to the RAP that brought you here.
GBC eWire
Horizontal
adjustment setscrew
Vertical adjustment
setscrew

ADJ 1.10 Element Tip Height Adjustment

Use the following procedure to ensure that the Element wire tip position is
correct, relative to the paper path. If the wire tips are too high or too low,
jams or mishooked sheets can occur.
Inspection Procedure
1) Do GP 6.3.6 to access the Functional Tests menu. Do the Feed
Element functional test. This will cause the eWire to feed one length
of wire and move it into the stack position.
2) Locate the Element Height Setup tool on the Book Drawer door.
Open the Cover, lift up the Vacuum Stacker and place the tool on the
element tips. Hold it horizontal against the tines on the Deflector.
3) Note the location of the Deflector tines relative to the tool. The top
edge of the tool should be lined up with the bottom of the upper
chamfer of the Deflector tine. A flashlight is useful for this step. Refer
to the following pictures.
01/26/2018
4-199
Repairs/Adjustments