Rep 8.9 Holder Rotate Motor Replacement M14 - GBC eWire Service Manual

8. Remove the M4 Screws (4) to remove the Motor Mounting Bracket
from the Holder
9. Remove the Pulley and remove the Motor Bracket Assembly from the
Holder.
10. Remove the M4 Screws (4) to remove the Motor from the Mounting
Bracket.
Installation Procedure
1. Attach the new Motor to the Mounting Bracket using the M4
Screws (4).
2. Position the Mounting Bracket Assembly within the Holder and
secure it using the M4 Screws (4).
3. Attach the Pulley and Belt to the Motor shaft and tighten the set
screw.
4. Attach the Sensor Cable to the S46 Sensor and secure the
cables using the cable clamps on the Motor Bracket.
5. Connect the Motor Cable to the appropriate Stepper Driver.
6. Replace the Back and Side cover.
7. Connect the Power Cord and resume operation.
GBC eWire

REP 8.9 Holder Rotate Motor Replacement M14

PARTS LIST ON PL 5.21
Use this procedure to remove and install the Holder Rotate Motor, M14
Removal Procedure
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Raise the Lid and Lower Transport Assembly.
4. Locate the Holder Rotate Motor on the Holder Frame.
5. Disconnect the Motor Cables at the header.
01/26/2018
4-151
WARNING
Repairs/Adjustments