Gp 6.10 Internal Inspection; Gp 6.11 External Cleaning; Gp 6.12 Internal Cleaning; Gp 6.13 Base Cleaning - GBC eWire Service Manual

GP 6.10 Internal Inspection

Do the following whenever the cover has been removed for corrective
maintenance.
1. Visually inspect for defects and problems such as damaged
components, loose screws or nuts, abraded wire insulation, loose
terminals, etc.
2. Correct any problems before returning the machine to service.

GP 6.11 External Cleaning

Do the following to clean the exterior of the eWire.
1. Clean the exterior covers with a soft cloth, mild detergent and warm
water. Use a minimal amount of water to avoid dripping onto sensitive
components.
2. Do not use chemical cleaners or solvents as these may have a
harmful effect. Use detergent sparingly to avoid contact with electrical
components.
Warning: Make sure you disconnect the eWire from its power source
before cleaning. Failure to observe this warning could result in death or
serious Injury. See Section 0, page vii for other languages.

GP 6.12 Internal Cleaning

Do the following to clean the interior of the eWire.
1. Open the doors and lid and remove paper dust and debris. Paper
dust can accumulate throughout the machine including around the
motors and other electrical components.
2. Use a vacuum cleaner if possible. A small paintbrush can also be
used but extreme care should be used around electrical components.
3. Clean non-electrical components with alcohol, an approved cleaner,
or a soft cloth moistened with mild detergent and warm water.
4. Clean the Rollers with alcohol.
Warning: Make sure you disconnect the eWire from its power source
before cleaning. Failure to observe this warning could result in death or
serious Injury. See Section 0, page vii for other languages.
GBC eWire

GP 6.13 Base Cleaning

Paper dust and particles fall to the bottom of the element feeder. Clean
every service call.
1. Clean with a vacuum cleaner each time the machine is serviced. The
customer can also do this between the technician's visits.
2. Clean dust off of the film covering S22 (GP 6.4.4) with a dry cloth

GP 6.14 Idler Roller and Idler Springs Inspection

Idler rollers press against the drive rollers and move the paper through
the eWire.
Maintenance Schedule
Inspect and clean every 1000K cycles.
Procedure
1. Inspect the rollers for wear, debris, toner marks, unevenness, and
dents.
2. Inspect springs (2) for each Idler Roller, and make sure they are
correctly hooked.
3. Inspect the Bearing Housing. The Bearing Housing should slide freely
in the Bearing Forks.
01/26/2018
6-63
General Procedures and Information