Adj 1.9 Holder Rotate Adjustment - GBC eWire Service Manual

18) Check and correct the deflector timing and alignment. Do GP 6.1 to
access the DEFLECTOR setting and the ALLIGNMENT setting.
A compass is provided on the Punched Hole Position Check Tool
to assist in determining the direction of the needed adjustment. The
arrow pointing in the direction the small hole needs to move in order
to be in its optimal position has a + or a – next to it and either the
word DEFLECTOR or ALLIGNMENT. + Means the value should be
increased in mm. – means the value should be decreased mm.
Make a small adjustment to the appropriate setting then repeat
Step 5-6 and 12-16.
The small holes are in their optimal positions
Yes- Go to Step 19
No- Repeat this step
19) Remove the die from the punch, reinsert the pins and reinstall the die.
Run books to verify the issue is corrected.
Issue is corrected
Yes- Return to normal operation
No- Return to the trouble shooting step that directed you here.
Repairs/Adjustments

ADJ 1.9 Holder Rotate Adjustment

The Holder rotation linkage can be adjusted to ensure the Holder is
properly vertical when in the vertical position or horizontal when in the
horizontal position. Follow the steps in this section to verify that the
Holder Rotate linkage is operating as expected.
Inspection Procedure
1) Do GP 6.3.6 to access the Functional Tests menu. Select the Holder
Rotate functional test, which will allow you to move the Holder into a
vertical or horizontal position.
2) Cycle the Holder from vertical to horizontal several times. Ensure that
the linkage moves smoothly. Check the bars in the linkage to see if
any of them are bent or loose.
3) With the linkage in the Horizontal position, ensure that the Holder
face is flat. A small level can be used for this purpose.
01/26/2018
4-198
GBC eWire