GBC eWire Service Manual page 268

6. Loosen the Set Screw securing the Pulley to the Motor Shaft.
7. Loosen the Screw securing the Crank Block to the Shaft, and remove
the Screw and Spacer.
8. Disconnect the Sensor Cables at the Holder Rotate Horizontal and
Holder Rotate Vertical Sensors. Refer to REP 8.2
Horizontal and Vertical Sensor S34 & S35
Repairs/Adjustments
9. Loosen the M4 Screws (4) and remove the Holder Rotate Assembly
10. Remove the #4-40 Screws (3) securing the Motor and remove the
Closer Rotate
01/26/2018
from the Holder.
Motor from the Holder Rotate Base.
4-152
GBC eWire