GBC eWire Service Manual page 161

6. Remove the M4 Screws (2) and the Driver and Bracket Assembly.
7. Remove the M2.5 Screws (2) from the vertical connector on the
Stepper Driver. Remove the Stepper Driver by releasing it from the
plastic standoffs.
GBC eWire
Installation Procedure
1. Place the new Stepper Driver onto the standoffs and snap it into
place.
2. Tighten the M2.5 Screws (2) to secure the vertical portion of the
Driver.
3. Attach the Driver PCB Bracket into the Frame by securing the M4
Screws (2).
4. Connect the Connectors (3).
5. Set the Dip switches (6) on the new Motor Driver in accordance with
the DIP Switch values indicated in GP 6.5.
6. Do REP 1.1 Top Cover Replacement
7. Connect the Power Cord.
8. Power ON the eWire.
01/26/2018
4-45
Dip Switches (6)
Connectors (3)
to install the Top Cover.
Repairs/Adjustments