Rep 1.3 Door Bottom Hinge Bracket Replacement - GBC eWire Service Manual

Installation Procedure
1. Place the Element Feeder Door in position so the pin on the lower
hinge bracket fits into the hole in the bottom of the door.
2. Place the upper mounting bracket onto the pin at the top of the door
and use M4 Screws (2) to attach the upper mounting bracket to the
machine frame. Align the mounting bracket with the marks made
before disassembly.
3. Do ADJ 1.7 to adjust the Interlock Flag if necessary.
4. Plug in the Power Cord.
5. Switch power ON to the eWire
Repairs/Adjustments

REP 1.3 Door Bottom Hinge Bracket Replacement

Use this procedure to remove and install the Door Bottom Hinge Bracket.
Removal Procedure
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Do REP 1.2 Element Feeder Door Replacement
Element Feeder Door.
4. Do REP 1.6 Side Cover Replacement
5. Use a nut driver to remove the Screws (2) securing the Door Bottom
Hinge Bracket to the machine.
Installation Procedure
1. Use a nut driver to tighten the Screws (2) mounting the new Door
Bottom Hinge Bracket to the machine. Use the markings from the old
Hinge Bracket as a guide to find the correct location.
2. Do REP 1.2 Element Feeder Door Replacement
Feeder Door.
3. Connect the Power Cord.
4. Power ON the eWire.
01/26/2018
4-6
to remove the
to remove the Side Cover.
to install the Element
GBC eWire