Rep 8.11 Holder Linear Drive Belt - Front Replacement - GBC eWire Service Manual

5. Remove the M4 Screws securing the Timing Belt Clamp, and remove
the Timing Belt Clamp.
6. Slide the Timing Belt off the Pulleys and remove the Timing Belt.
Installation Procedure
1. Place the new Timing Belt in position and align it to the Pulleys.
2. Secure the Timing Belt Clamp using the M4 Screws to secure the
Belt to the Closer.
3. Adjust the Timing Belt Bracket to appropriate belt tension and
secure the Timing Belt Bracket by tightening the Screws.
4. Connect the Power Cord
5. Turn power ON to eWire.
Repairs/Adjustments
REP 8.11 Holder Linear Drive Belt – Front Replacement
PARTS LIST ON PL 5.21
Use this procedure to remove and install the Holder Linear Drive Belt,
Front. Note that the same belt is also used on the rear side of the Holder.
Removal Procedure
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Open the Lid and Lower Bypass.
4. Loosen the M4 Screws securing the Timing Belt Bracket and adjust
the Bracket to relieve tension on the Belt.
01/26/2018
4-154
GBC eWire