GBC eWire Service Manual page 305

b) Check the vertical alignment as shown in Fig 3.B.
i) After moving the element holder into the element feeder,
check the engagement in the vertical direction. If the two do
not engage without hesitiation then an adjustment is needed.
ii) Performing Adjustment.
(1) Move the element holder into the element feeder and
leave the two engaged.
(2) Loosen the two screws on the Height Adjustment Bracket
as shown in Fig 3.C.
(3) Insert a flat head screw driver and very gently raise the
Height Adjustment Bracket (Fig 3.D) until it makes
contact with the bearing/CAM follower in the track. Do not
apply excessive pressure, contact is all that is needed
with the bearing.
(a) While applying pressure to lightly raise the bracket,
tighten the two screws.
(4) Perform the same check and adjustment on the rear of
the machine (not shown).
(5) After adjustment of the front and rear, by hand move the
element holder and check for smooth engagement with
GBC eWire
the element feeder.
01/26/2018
4-189
Repairs/Adjustments