Gp 6.3.13 Feed Belt Home Setting; Gp 6.3.14 Closer To Holder - GBC eWire Service Manual

GP 6.3.13 FEED BELT HOME Setting
The Feed Belt Home setting will allow the operator to change the position
the Element Feeder Belt reaches when it is in home position.
Using the procedure described in
Use the up and down arrows to scroll down to the FEED BELT HOME
option.
FEED BELT HOME
LOG
The below screen will appear
FEED BELT HOME
0
0 is the default setting. The Feed Belt Home value can be adjusted on a
range of -50 to +50. When the desired value has been selected, press
ENTER to return to the service menu.
Select EXIT and press ENTER to return to the top level menu.
GP 6.3.14 CLOSER TO HOLDER
The Closer to Holder setting will allow the operator to change the position
the closer stops at when moving to partial close the element on the
holder.
Using the procedure described in
Use the up and down arrows to scroll down to the CLOSER TO HOLDER
option.
CLOSER TO
HOLDER
General Procedures and Information
GP 6.1.3, enter Service mode.
*
*
GP 6.1.3, enter Service mode.
*
The below screen will appear
CLOSER TO
HOLDER
0
0 is the default setting. The Closer to Holder value can be adjusted on a
range of -256 to +256. When the desired value has been selected,
press ENTER to return to the service menu.
Select EXIT and press ENTER to return to the top level menu.
GP 6.3.15 PARTIAL CLOSE Setting
The Partial Close setting will allow the operator to change the amount the
closer closes down on the unbound element prior to binding
Using the procedure described in
Use the up and down arrows to scroll down to the PARTIAL CLOSE
PARTIAL CLOSE
The below screen will appear
PARTIAL CLOSE
0
0 is the default setting. The Partial Close value can be adjusted on a
range of -5 to +5. When the desired value has been selected, press
ENTER to return to the service menu.
Select EXIT and press ENTER to return to the top level menu
01/26/2018
6-18
*
GP 6.1.3, enter Service mode.
*
*
GBC eWire