J261- Excessive Alignment Offset Detected - GBC eWire Service Manual

RAP 3.4

J261- EXCESSIVE ALIGNMENT OFFSET DETECTED

J261 is an optional jam code that can be turned on or off through the
service menu. When turned on, J261 will occur when the eWire detects a
sheet coming into the machine with more alignment offset than eWire is
capable of correcting.
4. If J261 is occurring frequently, there could be misalignment between
the eWire and upstream device. Refer to Section 8 Installation and re-
check the alignment between eWire and the device feeding sheets to
eWire.
This clears the fault
Yes- Return to normal operation;
No- Go to step 2
5. If there are no problems with alignment between eWire and the
upstream device, check the upstream device to ensure that sheets
being fed from that device are in line with the sheet alignment
markings on eWire.
This clears the fault
Yes- Return to normal operation;
No- Go to step 3
6. Do GP 6.3.6 to access the Functional Tests Menu. From this menu,
Align Jam can be turned on or off. If J261 is occurring when sheets
are not entering the eWire with excessive skew, turn Align Jam option
off and evaluate the result.
This clears the fault
Yes- Return to normal operation;
No- Go to the RAP indicated by the new Jam Code.
If a paper transport jam code J1xx or J2xx is displayed that was notlisted
above, determine the location of the first jammed sheet.
If the first jammed sheet is in the transport section, go to RAP 2.1
GBC eWire
If the first jammed sheet is in the sheet stacking section, go to RAP 2.2
01-26-2018
2-21
RAPS