Rap 4.11 J351- S32 & S33 Both Blocked; Rap 4.12 J361- Residual Element Error - GBC eWire Service Manual

RAP 4.11 J351- S32 & S33 BOTH BLOCKED
J351 will occur when the S32 and S33 sensors are both blocked at the
same time. S32 and S33 sensors are both used on the Pushover
mechanism.
1. Open the Element Feeder drawer. Inspect the pushover mechanism
area for any debris or obstruction. Inspect the 4 Cams for damage.
Remove any foreign object that may be obstructing the area.
This clears the fault
Yes- Return to normal operation;
No- Go to step 2
2. Do GP 6.4.3 to check the S32 and S33 sensors.
This clears the fault
Yes- Return to normal operation;
No- Go to step 3
3. Do GP 6.5.7 to check the function of Motor 12 and Motor 13.
This clears the fault
Yes- Return to normal operation;
No- Go to step 4
4. Do REP 3.15 to remove the Expanding T mechanism from the eWire.
Thoroughly inspect and ensure no foreign objects are stuck in the
Expanding T. Replace the module and repeat steps 2 and 3.
This clears the fault
Yes- Return to normal operation;
No- Escalate to second level.
GBC eWire
RAP 4.12 J361- RESIDUAL ELEMENT ERROR
J361 is displayed when there is a residual element on the Element belt
somewhere between S21 Element detect at Knife and S22 Element
detect at Pyramid. Follow this procedure when this message is displayed
erroneously (i.e. when there is no element present on the belt)
1. Do GP 6.4 to check S21 Element Detect at Knife sensor
This clears the fault
Yes- Return to normal operation;
No- Go to Step 2
2. Do GP 6.4 to check S22 Element Detect at Pyramid sensor
This clears the fault
Yes- Return to normal operation;
No- Go to step 3
3. Replace the Element Feed Belt (ARP 3.6)
This clears the fault
Yes- Return to normal operation;
No- Go to step 4
4. Check the Element Feed Belt area for dust and debris. Use
compressed air to clean the areas around S21 and S22
This clears the fault
Yes- Return to normal operation;
No- Escalate to second level
01-26-2018
2-38
RAPS