Rep 2.26 Upper Transport Latch Replacement - GBC eWire Service Manual

REP 2.26 Upper Transport Latch Replacement

PARTS LIST ON PL 5.4
Use this procedure to remove and install the latch on the Upper Bypass
Assembly.
Removal Procedure
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Do REP 1.1 Top Cover Replacement
4. While supporting the upper transport with your free hand, release the
latch by pressing down on the pivot arm. Raise the Upper Bypass
carefully, it will rise quickly without the weight of the cover.
5. Remove the old Latch Assembly by removing the M4 Screws (4)
GBC eWire
to remove the Top Cover.
Latch
Assembly
Latch Catch
Interlock
Bracket
Installation Procedure
1. Place the new Latch onto the Upper Transport surface and secure it
with the M4 Screws (4).
2. Lower the Upper Bypass and check the alignment of the new latch to
the Latch Catch. If necessary, loosen the M4 Screws (2) securing the
Interlock Bracket to the Frame and shift the Interlock Bracket until the
Latch Catch is centered on the Latch Hook. If horizontal adjustment of
the Interlock Bracket is required, do REP 1.8
Replacement to remove the Front Cover.
3. Close the latch by lowering the Upper Bypass Assembly fully. Ensure
that the latch engages properly with the Catch. If necessary, adjust
the vertical position of the Catch by loosening the Screws on the
Catch Bracket and adjusting the position.
4. Do REP 1.1 Top Cover Replacement
5. Connect the Power Cord.
6. Power ON the eWire.
01/26/2018
4-47
Front Cover
to install the Top Cover.
Repairs/Adjustments