Gp 6.7 Supply Spool Installation - GBC eWire Service Manual

GP 6.7 Supply Spool Installation
Do the following procedure to install a new supply spool into the eWire. If
you need to remove a spool that is not yet empty first, first do GP 6.8.
1. Stop the Printer/Copier. Open the eWire access door panel and slide
the Element Feeder Drawer out.
2. If applicable, go to GP 6.8 to remove the previously installed element
spool.
3. Remove the wire shield by pulling on the handle to remove it. Place it
on top of the
4. Remove the spool holder cap from the spindle by turning it counter-
clockwise.
General Procedures and Information
5. Remove spool from carton and remove the plastic shrink wrap. Place
a flexible magnet on the spool behind the flat cardboard insert. Do not
remove the cardboard insert until the wire is secured.
6. Install the spool by sliding it onto the Spindle Shaft. The circular bar
code must be facing towards the inside of the Element Feeder.
Secure the spool by tightening the Spool Holder Cap.
7. After confirming that the flexible magnet is securing the wire end,
carefully remove the cardboard spacer.
01/26/2018
6-56
GBC eWire