GBC eWire Service Manual page 255

REP 7.2 Tapper Motor Replacement M6 & M7
PARTS LIST ON PL 5.17
Use this procedure to remove and install the Motor on the Front Tapper
Assembly, Motor M6. Note: The same procedure can be used to replace
Motor M7 on the Rear Tapper Assembly.
Removal Procedure
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Do REP 7.1 Front Tapper Assembly Replacement
Front Tapper Assembly.
4. Disconnect the Front Tapper Spring by lifting it off the notch on the
Tapper Frame.
5. Loosen the Set screw securing the Tapper hub to the Motor shaft.
GBC eWire
6. Remove the Tapper hub from the Motor.
to remove the
7. Remove the #4-40 Screws (3) to remove the Tapper Motor from the
Tapper Frame.
01/26/2018
4-139
Repairs/Adjustments