Gp 6.3.11 Workflow Procedure; Gp 6.3.12 Max Bypass Setting - GBC eWire Service Manual

GP 6.3.11 WORKFLOW Procedure
The workflow adjust menu will allow you to choose between two different
modes of operation in the eWire. In job mode, an element will be cut and
readied as needed for the next book. In streaming mode, elements will be
cut and readied continuously in order to increase throughput. Job mode is
recommended for the majority of cases.
Using the procedure described in
Use the up and down arrows to scroll down to the WORKFLOW
option. Press ENTER to enter workflow adjust mode.
WORKFLOW
SPEED
Press the up and down arrows to adjust between Job and Streaming
modes. Press ENTER when the desired mode of operation is
selected.
WORKFLOW
JOB
You will return to the Service mode menu.
GBC eWire
GP 6.1.3, enter Service mode.
GP 6.3.12 MAX BYPASS Setting
Do the following to set the maximum bypass sheet length through eWire.
Using the procedure described in
Use the up and down arrows to scroll down to the MAX BYPASS option.
MAX BYPASS
DFA SETTINGS
The below screen will appear
MAX BYPASS
488mm
762mm is the Max Bypass setting. To reduce the Max Bypass setting,
press the down arrow to the desired setting, and then press OK. You
will return automatically to the service menu.
01/26/2018
6-17
GP 6.1.3, enter Service mode.
*
*
General Procedures and Information