Rep 8.2 Closer Rotate Horizontal And Vertical Sensor S34 & S35 - GBC eWire Service Manual

8. Remove the Closer Home Sensor S46 by removing the M3 Screw.
Installation Procedure
1. Install the new Sensor by tightening the M3 Screw. Use tab for
alignment.
2. Connect the Sensor Cable.
3. Close the Lid
4. Connect the Power Cable
5. Turn power ON to the eWire.
Repairs/Adjustments
REP 8.2 Closer Rotate Horizontal and Vertical Sensor S34 & S35
PARTS LIST ON PL 5.22
Use this procedure to remove and replace the Closer Rotate Sensors,
horizontal and vertical.
Removal Procedure
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Turn off Power to the eWire.
2. Disconnect the Power Cord.
3. Raise the Lid and Lower Bypass.
4. If necessary, manually move the Closer forward to access the
sensors.
5. Disconnect the Sensor Cables.
6. Remove the Sensor removing the M3 Screw.
01/26/2018
4-144
GBC eWire