Rep 10.5 Book Tray Belt Removal Procedure - GBC eWire Service Manual

REP 10.5 Book Tray Belt Removal Procedure

PARTS LIST ON PL 5.24
Use this procedure to remove and install the Belt for the Book Tray Drive
Motor.
Removal Procedure
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Turn off Power to the eWire.
2. Disconnect the Power Cord.
3. Slide the Book Drawer Tray all the way out of the eWire.
4. Remove the Book Tray Rear Cover by removing the M4 Screws (4).
5. Loosen the set screws on the Pulleys on the Motor Shaft and Drive
Shaft.
6. Slide the pulleys and Belt off the shafts and remove the Belt.
Repairs/Adjustments
Installation Procedure
1. Wrap the new Belt around the Motor Shaft Pulley and Drive Pulley
and slide the Pulleys onto their respective Shafts.
2. Secure the pulleys in place by tightening the set screws.
3. Replace the Rear Cover
4. Close the Door.
5. Connect the Power Cord.
6. Turn on power to the eWire.
01/26/2018
4-178
GBC eWire