Rep 8.4 Holder Position Closer And Holder Position Element Sensor S36 And S38 - GBC eWire Service Manual

1. Install the new Sensor by tightening the M3 Screw. Use tab for
alignment.
2. Connect the Sensor Cable.
3. Close the Lid
4. Connect the Power Cable
5. Turn power ON to the eWire.
REP 8.4 Holder Position Closer and Holder Position Element
Sensor S36 and S38
PARTS LIST ON PL 5.20
Repairs/Adjustments
Use this procedure to remove and replace the Holder Position Element
Sensor S38, and the Holder Position Closer Sensor S36.
Removal Procedure
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Turn off Power to the eWire.
2. Disconnect the Power Cord.
3. Do REP 1.5 Back Cover Replacement
4. Locate the Holder Position Closer Sensor, located on the rear of the
Holder near the Drive Pulley. Refer to PL 5.20 and GP 6.4.3.
5. Locate the Holder Position Element Sensor, located on the rear of the
Holder at the other side of the cutout. Refer to PL 5.20 and GP 6.4.3.
6. Disconnect the Sensor Cable.
7. Remove the Holder Position Closer Sensor by removing the M3
Screw.
8. Remove the Holder Position Element Sensor by removing the M3
Screw.
01/26/2018
4-146
to remove the Back Cover.
GBC eWire