GBC eWire Service Manual page 193

6. Disconnect the Sensor Cable from the Sensor.
7. Remove the M3 Screw securing the sensor and remove the old
Sensor.
GBC eWire
Installation Procedure
1. Align the new Sensor on the Sensor Bracket using the tab. Secure
the new Sensor to the Sensor Bracket using the M3 Screw.
2. Connect the Sensor Cable to the Knife Home Sensor.
3. Secure the Sensor Bracket by using the M3 Screws (3).
4. Secure the Upper Cable Cover by tightening the M3 Screws (2).
5. Do REP 3.15
6. Connect the Power Cord.
7. Power ON the eWire.
Sensor Cable
Connection
01/26/2018
4-77
Knife Module Replacement to install the Knife Module.
Repairs/Adjustments