Gp 6.3.8 Element Settings Procedure - GBC eWire Service Manual

7. Press the down arrow to scroll through the Firmware Upgrade
options.
•
MAIN Board A – Select this to update the A Board firmware.
•
MAIN Board B – Select this to update the B Board firmware.
•
COMMS (The Communications Board) – Select this to update the
Comm firmware
8. Press the ENTER button when the return symbol is next to the Board
that you want to upgrade the firmware for.
A
B
9. When update is complete for the A or B boards, the system will
display the screen shown below. Press ENTER to return to the
Firmware Upgrade Menu. When update is complete for the COMM
board, you will return automatically to the previous screen.
COMPLETE
10. Press ENTER to return to the Main Screen.
11. Remove the USB flash drive with the firmware file you uploaded.
12. Install the Cover for USB port and tighten the Screws (2).
13. Switch off the machine. Wait 10 seconds, and then switch the
machine back on again. Do GP 6.2.8
verify the Firmware revision is correct.
GBC eWire
*
to check the firmware, and
GP 6.3.8 ELEMENT SETTINGS Procedure
The Element Settings option allows the user to change the position of the
"Holder at Stack" and "Holder at Closer" positions. Changing this value
will cause the travel of the Holder to be slightly more or less at the
position selected.
Enter Service Mode by following the procedure described in
Press the down arrow until the return symbol is next to the words
ELEMENT. Press Enter.
ELEMENT
STACK POSITION
0
Note the current value before making any changes, so you have a
reference point to return to.
The stack position can be changed on a range of -50 to +50
Any changes made to STACK POSITION will apply only to the selected
element size. The settings will be remembered when running that size in
the future, but other sizes will not be affected.
Press ENTER to save the selected value. You will return to the service
menu.
01/26/2018
6-15
GP 6.1.3
General Procedures and Information