GBC eWire Service Manual page 143

7. Remove the Screws and Washers (4) and remove the Stepper Mount
Bracket from the Frame.
8. Remove the Motor Timing Pulley from the Motor shaft by pulling it off
of the shaft.
9. Remove the Stepper Motor from the Motor Bracket by removing the
M4 screws (4)
GBC eWire
1. Install the Stepper Motor Pulley onto the Motor shaft
2. Install the Motor onto the Motor Bracket by tightening the M4 Screws
Washers (4)
3. Place the Motor Bracket Assembly in position and tighten the Screws
4. Connect the Motor Connector.
5. Adjust the Belt tension. The belt should be taut but still be able to flex
Screws (4)
6. Do REP 1.1
7. Connect the Power Cord.
8. Power ON the eWire.
01/26/2018
4-27
Installation Procedure
(4). Note the directional orientation of the motor cable.
(4).
approximately 1" when you press on it.
Top Cover Replacement to install the Top Cover.
Repairs/Adjustments