Rep 2.21 Steering Module Replacement - GBC eWire Service Manual

REP 2.21 Steering Module Replacement

PARTS LIST ON PL 5.6
Use the following procedures to remove and install the Steering Module,
containing Nips N4 and N5.
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Raise the Upper Bypass Lid
4. Disconnect the Grounding Strap from the Frame by removing the M3
Screw
5. Disconnect the Cables from the Steering Module, located on the rear
of the module.
GBC eWire
6. Disconnect the Steering Module Assembly by removing the M4
Screws from the front of the frame (4) and the back of the frame (3).
Support the Steering Module with your free hand while removing the
last screws.
7. Carefully slide the Steering Module out of the Lower Bypass.
01/26/2018
4-41
Repairs/Adjustments