Rep 4.2 Solenoid Replacement, Kickdown Solenoid, Rear (L7) - GBC eWire Service Manual

REP 4.2 Solenoid Replacement, Kickdown Solenoid, Rear (L7)

PARTS LIST ON PL 5.14
Use this procedure to remove and install the rear Kickdown Solenoid
Assembly.
Removal Procedure
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Do REP 4.1 Vacuum Stacker Module Replacement
Vacuum Stacker.
4. Remove (3) M3 Screws securing the rear cover and remove the
cover.
GBC eWire
5. Disconnect the solenoid wires at the header
6. Loosen the set screw securing the clevis to the rotating shaft.
to remove the
7. Disconnect the extension spring from the kick-down solenoid
assembly.
01/26/2018
4-99
Repairs/Adjustments