Rep 11.6 Power Switch Replacement - GBC eWire Service Manual

Installation Procedure
1. Insert the AC Filter into the electrical panel and tighten the M3 Screws
(2).
2. Connect the Wires (3) to the AC Filter, maintaining the previous
locations.
3. Do REP 1.5 to install the Rear Cover.
4. Connect the Power Cord.
5. Power ON the eWire.
Repairs/Adjustments

REP 11.6 Power Switch Replacement

Use this procedure to remove and install the Power Switch.
Removal Procedure
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Press the Power switch to OFF position.
2. Disconnect the Power Cord.
3. Do REP 1.5 Back Cover Replacement
4. Note the wire connection locations (White/Black/Green) on the back
of the Switch.
5. Disconnect the wires from the back of the Switch
6. Press the Tabs and remove the Switch from the Panel.
01/26/2018
4-184
to remove the Back Cover.
GBC eWire