Rep 3.11 Element Feed Belt Idler Replacement - GBC eWire Service Manual

REP 3.11 Element Feed Belt Idler Replacement

PARTS LIST ON PL 5.9
Use this procedure to remove and install the Element Feed Belt Idler.
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
Removal Procedure
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Open the Front Door and slide out the Element Feeder drawer.
4. Do GP 6.8 to remove the Supply Spool.
5. Remove the Element Feeder Belt Cover by removing the M4 Screws
(3).
GBC eWire
6. Using a screwdriver, remove the e-ring from the end of the Ider shaft.
7. Slide the outermost Flange and Bearing off of the shaft and set it
aside. Gently slide the plastic Idler Pulley off the shaft, carefully
disengaging it from the Belt.
01/26/2018
4-67
Repairs/Adjustments