GBC eWire Service Manual page 378

Locate Sensor S24:
•
Slide the Element Feeder Drawer all the way out of the eWire.
•
Manually raise and lower the pushover mechanism to block
and unblock the sensor.
S24 is located on the Element Transfer Module
GBC eWire
Locate Sensor S31:
•
Slide the Element Feeder Drawer all the way out of the eWire.
•
Locate the Pushover Motor on the rear side of the Element
Transfer Module.
•
Remove the Sensor Bracket by removing the M3 Screws (3),
without disconnecting the Sensor cable.
•
The sensor can be blocked and unblocked using a piece of
paper or other object.
S31 is located on the Element Transfer Module
01/26/2018
6-27
General Procedures and Information