Rep 1.7 Book Tray Door Replacement - GBC eWire Service Manual

REP 1.7 Book Tray Door Replacement

PARTS LIST ON PL 5.28
Use this procedure to remove and install the Book Tray Door.
Removal Procedure
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Slide out the Book Tray by pulling on the handle.
4. Remove the M4 Screws (3) from the left side cover plate, while
holding the cover secure with your free hand. Remove the cover plate
and set it aside.
5. Remove the M4 Screws (3) from the right side cover plate, while
holding the cover plate secure with your free hand. Remove the cover
plate and set it aside.
GBC eWire
6. Remove the M4 Screws (2) from the lower half of the Book Tray Door.
7. While securing the door with your free hand, remove the M4 Screws
(2) from the upper half of the Book Tray Door. One screw is on each
side of the door. Carefully slide the Door off the Book Drawer and
away from the eWire.
8. Lift the Door up off the mounting brackets and remove from the
machine.
01/26/2018
4-9
Repairs/Adjustments