Rep 2.27 Lower Transport Latch Replacement - GBC eWire Service Manual

REP 2.27 Lower Transport Latch Replacement

PARTS LIST ON PL 5.4
Use this procedure to remove and install the latch on the Lower Bypass
Assembly.
Removal Procedure
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Raise the Upper Bypass and Lower Bypass.
4. Remove the old Latch by removing the M4 Screws (2)
Repairs/Adjustments
Installation Procedure
1. Place the new Latch onto the Lower Transport surface and secure it
with the M4 Screws (2).
2. Close the Lower Transport and ensure that the latch mates easily
with housing. If necessary, loosen the screws on the latch hook or
mating housing and adjust the position to ensure proper fit.
3. Connect the Power Cord.
4. Power ON the eWire.
01/26/2018
4-48
GBC eWire