Rep 2.5 Idler Roller Replacement, Steering Module - GBC eWire Service Manual

Installation Procedure
1. Place the new Idler Roller with Bearing Housings into the Bushing
Forks.
2. Make sure the flat surface of the bushing aligns in the fork.
3. Rollers are non-directional so it does not matter which end goes in
each fork.
4. After the assembly is in place, gently pull the assembly outward and
release to ensure it moves freely in the fork.
5. Place the Extension Spring (2) over the Bearing Housings (2).
6. Place the hooks on the ends of the Extension Springs (2) on the
notches at the top of the Bushing Forks (2).
7. Do REP 1.1 Top Cover Replacement
8. Connect the Power Cord.
9. Power ON the eWire.
Repairs/Adjustments
to install the Top Cover.

REP 2.5 Idler Roller Replacement, Steering Module

PARTS LIST ON PL 5.5
Use this procedure to remove and install the Idler Rollers on the following
Nips: N4 and N5
Removal Procedure
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Raise the Upper Bypass Panel
4. Remove the Extension Spring (2) by unhooking the spring ends from
the hooks on the mounting bracket.
5. Slide the Idler Roller Assembly out of the Steering Module by lifting
the bearings out of the bearing mount brackets
01/26/2018
4-20
GBC eWire