GBC eWire Service Manual page 151

6. Remove the M4 Screws (2) and the Driver and Bracket Assembly.
7. Remove the M2.5 Screws (2) from the vertical connector on the
Stepper Driver. Remove the Stepper Driver by releasing it from the
plastic standoffs.
GBC eWire
Screws (2)
Installation Procedure
1. Place the new Stepper Driver onto the standoffs and snap it into
place. Note the orientation of the Driver PCB.
2. Tighten the M2.5 Screws (2) to secure the vertical portion of the
Driver.
3. Attach the Driver PCB Bracket into the Frame by securing the M4
Screws (2).
4. Set the Dip switches (6) on the new Motor Driver, using the correct
settings for the Stepper Motor in question. Refer to GP 6.5 for DIP
Switch settings.
5. Connect the Connectors (3).
6. Do REP 1.1 Top Cover Replacement
7. Connect the Power Cord.
8. Power ON the eWire.
01/26/2018
4-35
Dip Switches
(6)
Connectors
(3)
to install the Top Cover.
Repairs/Adjustments