GBC eWire Service Manual page 411

7. Secure the wire using a magnet as shown. Repeat steps 3 and 5 until
all the wire is on the spool.
8. Secure the wire rows on the spool at the end of the lose wire using
the 2 nd magnet strip, then move the first magnet strip you placed as
shown here. Place the magnets across rows of wire so that the loose
end of wire is secured to the wound rows. The magnets prevents the
wire from slipping when the spool is removed.
General Procedures and Information
9. Tear the carrier paper where it leaves the rewind spool. Your carrier
paper should extend about 12 inches (30 cm) beyond the loose end
of your wire.
10. Unscrew the spool retainer. Turn the knob counterclockwise to loosen
and remove the cap. Set the cap aside.
01/26/2018
6-60
GBC eWire