Rep 2.14 Skew Measurement Sensor Replacement, S6-S10 - GBC eWire Service Manual

6. Remove the Sensor Bracket by removing the M4 Nut.
7. Remove the old sensor from the Sensor Bracket by removing the M3
Screw.
Installation Procedure
1. Place the Sensor in position, then install and tighten the Screw.
2. Connect the Sensor Connector.
3. Do REP 1.1 Top Cover Replacement
4. Connect the Power Cord.
5. Power ON the eWire.
Repairs/Adjustments
to install the Top Cover.

REP 2.14 Skew Measurement Sensor Replacement, S6-S10

PARTS LIST ON PL 3.7
Use the following procedures to remove and install the Skew Sensors,
S6-S10. The Skew Sensors are located on the Skew Sensor PCB
(7715692).
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Do REP 1.1 Top Cover Replacement
4. Locate the Skew Sensor PCB on the Bypass Panel.
5. Disconnect the Connector from the PCB.
6. Remove the Cover from the Steering Module by removing the M3
Screws.
7. Release the Skew Sensor Cable from the cable clips on the Cover
Support Bracket.
01/26/2018
4-30
to remove the Top Cover.
GBC eWire