Rep 1.2 Element Feeder Door Replacement - GBC eWire Service Manual

Installation Procedure
Use this procedure to install the top cover assembly
1. Switch power OFF to eWire.
2. Disconnect the Power Cord from eWire.
3. Lower the Upper Transport until the latch engages.
4. Lower the Top Cover Assembly onto the Upper Transport.
5. Lift up the Upper Transport by releasing the latch, while holding the
Top Cover in place on the Transport Frame.
6. Line up the screw holes in the frame with the threaded holes in the
Top Cover mounting brackets.
7. Install and tighten the Socket Head Screws (4) through the holes in
the frame.
8. Connect the Power Cord.
9. Switch power ON the eWire
GBC eWire

REP 1.2 Element Feeder Door Replacement

PARTS LIST ON PL 5.28
Use this procedure to remove and install the Element Feeder Door
Assembly
Removal Procedure
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Do REP 1.8 Front Cover Replacement
4. Remove the M4 Screws (2) from the Upper Hinge Bracket while
holding the door with your free hand to prevent movement. Remove
the Upper Hinge Bracket while still supporting the weight of the door.
5. Lift the Door up off the pin on the lower hinge bracket.
6. Remove the Element Feeder Door.
01/26/2018
4-5
WARNING
to remove the Front Cover.
Repairs/Adjustments