GBC eWire Service Manual page 379

Locate Sensor S32 and S33:
•
Slide the Element Feeder Drawer all the way out of the
eWire.
•
Remove the Element Feeder Cover 7717335 by removing
the M3 Screws (4). Refer to REP 3.16.3.
•
If necessary, go to GP 6.3.5 and use the Motors Procedure
to cycle Motor M13. Remove the Interlock Cheater when the
sensor flag is in the desired location. This will allow you to
block or unblock each sensor.
S32 and S33 are located on the Expanding T Module
General Procedures and Information
Locate Sensor S34 and S35:
•
Raise the Top Cover
•
Manually move the closer module forward if needed to view
the Holder Rotate linkage
•
If the sensor is unblocked, it can be blocked by inserting a
piece of paper or other solid object.
•
If the sensor is blocked, do REP 8.2 to remove the Holder
Rotate Bracket, but do not disconnect the Sensor cables.
This will allow you to block or unblock the sensor manually.
S34 and S35 are located on the Holder Module Rotate Mechanism
01/26/2018
6-28
GBC eWire