Gp 6.3.9 Deflector Procedure - GBC eWire Service Manual

GP 6.3.9 DEFLECTOR Procedure
The Deflector position setting will change the timing offset for the
Deflector module. The default value is 0. The timing offset relates to the
amount of time that passes from the Deflector Sensor detecting a sheet to
the deflector solenoids firing.
Enter Service Mode by following the procedure described in
Press the down arrow until the return symbol is next to the words
DEFLECTOR. Press Enter.
DEFLECTOR
Note the current value before making any changes, so you have a
reference point to return to.
DEFLECTOR
0
The deflector timing can be changed on a range of -5.0mm to +5.0mm.
Press ENTER when the desired value is flashing to save the Deflector
settings. You will return automatically to the service menu.
Any changes made to the Deflector Timing values will apply only to the
currently installed element size. The settings will be remembered when
the same size is installed again, but other sizes will not be affected. If no
spool is currently installed, an error message will occur.
General Procedures and Information
GP 6.3.10
The Log procedure allows you to save information about machine settings
and past performance to a USB drive.
Enter Service Mode by following the procedure described in
Remove the Screws and remove the USB cover to access the USB port
GP 6.1.3
on the rear of the eWire. Insert a USB drive to the port.
Press the down arrow until the return symbol is next to the words LOG.
Press Enter.
Only one option, will be available, Save to USB. This will save the current
log file to a USB storage device located on the back panel. The file name
will be LOG0001.txt, and increment each time the log is saved.
Press Enter to save the current Log File to your USB storage device. You
will receive a message showing the log has been saved and the name of
the Log File. Press ENTER to return to the service menu.
01/26/2018
6-16
LOG Procedure
LOG
SAVE TO USB
PREVIOUS MENU
GP 6.1.3
GBC eWire