Rep 3.5 Spool Near-Empty Sensor Replacement - S50 - GBC eWire Service Manual

REP 3.5 Spool Near-Empty Sensor Replacement – S50
PARTS LIST ON PL 5.7
Use this procedure to remove and install the Spool Near-Empty Detect
Sensor. Note that the Sensor is located on the Spool Empty PCB
7717479.
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
Removal Procedure
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Open the Front Door and slide out the Element Feeder drawer.
4. Do GP 6.8 to remove the Supply Spool.
5. Remove the Spool Detect Sensor Cover by removing the M4 Screws
(2).
GBC eWire
6. Remove the M3 Screws (2) and remove the Spool Empty PCB from
its mounting bracket.
7. Disconnect the Sensor Cable from the back side of the PCB.
Installation Procedure
1. Reverse the steps in the Removal Procedure.
2. Connect the Power Cord.
3. Power ON the eWire.
01/26/2018
4-55
Repairs/Adjustments