Element Feeder; Rep 3.1 Element Slack Sensor Replacement - S20 - GBC eWire Service Manual

3. Element Feeder

REP 3.1 Element Slack Sensor Replacement – S20
PARTS LIST ON PL 5.7
Use this procedure to remove and install the Element Slack Sensor.
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
Removal Procedure
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Open the Front Door and slide out the Element Feeder drawer.
4. Do GP 6.8 to remove the Supply Spool.
5. Remove the Spool Detect Cover by removing the M4 Screws (3).
GBC eWire
6. Remove the curved Rear Baffle by removing the M4 Screws (6)
7. Disconnect the Sensor Cable.
8. Remove the Sensor Bracket by removing the M3 Screws (2)
9. Using a wrench or screwdriver, remove the Sensor from the Sensor
Bracket by removing the M3 Screw.
01/26/2018
4-49
Repairs/Adjustments