Rep 3.15 Element Transfer Module Replacement - GBC eWire Service Manual

REP 3.15 Element Transfer Module Replacement

PARTS LIST ON PL 5.12
Use this procedure to remove and install the Element Transfer Module,
which also carries the Expanding T Module.
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
Removal Procedure
5. Switch power OFF to eWire.
6. Disconnect the Power Cord.
7. Open the Front Door and slide out the Element Feeder drawer.
8. Do GP 6.8 to remove the Supply Spool.
9. Remove the Element Feeder Rear Panel by removing the M4 Screws
(8). The bottom 2 screws can be used as a pivot to aid assembly.
Repairs/Adjustments
10. Remove the M4 Screws (2) securing the Upper Element Feeder
Cover
11. Disconnect the cable to the Element Transfer Module at the header.
01/26/2018
4-80
GBC eWire