Rep 1.4 Door Top Hinge Bracket Replacement; Rep 1.5 Back Cover Replacement - GBC eWire Service Manual

REP 1.4 Door Top Hinge Bracket Replacement

Use this procedure to remove and install the Door Top Hinge Bracket.
Removal Procedure
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Do REP 1.2 Element Feeder Door Replacement
Element Feeder Door.
4. Use a nut driver to remove the Screws (2) mounting the Door Top
Hinge Bracket to the machine.
Installation Procedure
1. Use a nut driver to tighten the Screws (2) mounting the new Door Top
Hinge Bracket to the machine.
2. Do REP 1.2 Element Feeder Door Replacement
Feeder Door.
3. Connect the Power Cord.
4. Power ON the eWire.
GBC eWire

REP 1.5 Back Cover Replacement

PARTS LIST ON PL 5.28
Use this procedure to remove and install the Back Cover.
Removal Procedure
to remove the
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to eWire
2. Disconnect the Power Cord.
3. Hold the Back Cover in place so it doesn't fall as you remove the M4
4. Carefully tilt the Back Cover back and then lift the Back Cover out of
to install the Element
01/26/2018
4-7
WARNING
Screws (2) from the Back Cover.
the tabs in the machine frame.
Repairs/Adjustments