Rep 2.2 Drive Roller Replacement - Steering Module - GBC eWire Service Manual

Installation Procedure
1. Place the Drive Roller in position
2. Install the Bearing at the front of the machine.
3. Install the Bearing at the rear of the machine.
4. Replace the Washer and E-Ring at the front of the machine.
5. Do REP 2.7 Belt Drive Timing Pulley Replacement
Roller Pulley.
6. Do REP 2.8 (Nips N1 – N3) or
Timing Belt. Do this after all Drive Rollers you plan to replace have
been replaced.
7. Do REP 1.1 Top Cover Replacement
8. Connect the Power Cord.
9. Power ON the eWire.
Repairs/Adjustments
to install Drive
REP 2.9 (Nips N10 – N15) to install the
to install the Top Cover.
REP 2.2 Drive Roller Replacement – Steering Module
PARTS LIST ON PL 5.5
Use this procedure to remove and install the Steering Module Drive Roller
Assembly, Nips N4 and N5.
Removal Procedure
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Raise the Upper Bypass Panel
4. Do REP 2.21 Steering Module Replacement
Module from the Machine.
5. Remove the Panel Assembly by removing the M3 Nuts (4) on the
underside of the Panel Assembly, located just above the rollers.
6. Remove the Drive Panel assembly by removing the M3 Nuts (4). Set
the Idler and Drive Panel assemblies aside.
7. Remove the E-Ring, Compression Spring, and Washer from the
Steering Drive Roller Shaft.
01/26/2018
4-16
to remove the Steering
GBC eWire