Rep 4.10 Drag Finger Adhesive Grip Replacement - GBC eWire Service Manual

REP 4.10 Drag Finger Adhesive Grip Replacement

PARTS LIST ON PL 5.15
Use this procedure to remove and install the Vacuum Stacker Drive Belt.
Removal Procedure
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Do REP 4.1 Vacuum Stacker Module Replacement
Vacuum Stacker.
4. Using a flat head screwdriver or knife, carefully peel up one corner of
the Drag Finger Adhesive Grip. Then remove the remaining material
by peeling it away from the surface of the Vacuum Stacker.
Repairs/Adjustments
Installation Procedure
1. Clean the adhesion surface, removing all material left over from
2. Remove the paper backing from the adhesive side of the
3. Carefully Align the Drag Finger Adhesive Grip to the mating
4. Press the new Drag Finger Adhesive Grip to the material and
5. Do REP 4.1
to remove the
6. Connect the Power Cord
7. Turn on the eWire.
01/26/2018
4-114
the previous Adhesive Grip part. Wipe the surface clean with a
rag and alcohol.
Adhesive Grip material.
surface, using the outline from the previous material if possible.
press it down flat.
Vacuum Stacker Module Replacement
Vacuum Stacker.
to replace the
GBC eWire