Rep 3.10 Element Feed Track Assembly Replacement - GBC eWire Service Manual

Installation Procedure
1. Reverse the steps found in the Removal Procedure.
2. Connect the Power Cord.
3. Power ON the eWire.
GBC eWire

REP 3.10 Element Feed Track Assembly Replacement

PARTS LIST ON PL 5.9
Use this procedure to remove and install the Element Feed Track
Assembly 7716577.
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
Removal Procedure
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Open the Front Door and slide out the Element Feeder drawer.
4. Do GP 6.8 to remove the Supply Spool.
5. Do REP 3.6 Element Feeder Belt Replacement
Element Feed Belt.
6. Do REP 3.2 and REP 3.3
7. Remove the M4 Screws (3) securing the Element Feed Track
Assembly to the frame.
01/26/2018
4-65
WARNING
to remove the
to remove sensors S22 and S25.
Repairs/Adjustments