Configure The Ewire; Run In Bypass Mode - GBC eWire Service Manual

4. Connect the Power Cord to AC power outlet.
5. Press the Power Switch to the On (I) position.
6. Wait until the User Interface indicates that the eWire is READY.
READY
TO BIND
GBC eWire

8.9. Configure the eWire

1. Do GP 6.2.4 LANGUAGE MODE Procedure to set the desired
language.
2. Do GP 6.3.1 SPEED Procedure to set the line speed.
3. Do GP 6.2.3 PAPER SIZE Procedure to set the desired paper
size.
4. Do GP 6.3.7 to install the Firmware, latest revision
5. When installing downstream of a SFP, confirm that the PFIM
software is level 4.32 or higher. Contact Xerox Support if the
software version is not available on GSN.
6. When the eWire is connected to the Versant Family of printers
configure the NVM setting per the table below.
Printer
Versant 80
Versant 180
Versant 2100
Versant 3100

8.10. Run in Bypass Mode

Put the eWire into Bypass mode to allow paper to pass through the eWire
without being diverted.
1. From the top level screen of the LCD User Interface, press either
the Up Arrow Button or the Down Arrow Button.
2. Do GP 6.2.5 to enter Bypass Mode.
3. READY - BYPASS should appear on the LCD.
4. Program the printer to feed a diagnostics job into the EWire in
BYPASS mode, and check that the sheets pass through the EWire
properly.
01/26/2018
8-11
NVM Value
740-498 = 1
740-498 = 1
740-499 = 1
740-499 = 1
Installation Instructions