GBC eWire Service Manual page 153

7. Remove the M4 Nuts (2) from the Diverter Solenoid Mount Bracket
and partially remove the Bracket.
8. Using an adjustable wrench, remove the Nut securing the Solenoid to
the Diverter Solenoid Mount Bracket.
9. Slide the Diverter Solenoid Sub-Assembly through the mounting hole
and out of the Mounting Bracket.
GBC eWire
Installation Procedure
1. Remove the Nut from the new Diverter Solenoid Linkage
Assembly.
2. Thread the linkage through the mounting hole and place the
Solenoid body into place on the Mounting Bracket. Loosely
tighten the Solenoid Nut to the Solenoid threads.
3. Align the Diverter Solenoid Mounting Bracket onto the studs on
the Bypass frame. Tighten the M4 nuts to secure the Solenoid
Mounting Bracket.
4. Tighten the M4 Screws (2) to secure the linkage to the Diverter
Shaft, rotating the Solenoid body as necessary to achieve
alignment.
5. Tighten the Solenoid Nut to secure the Solenoid Body.
6. Connect the Solenoid Cables, threading the wires through the
cable clamps.
7. Re-install the Lower Bypass Rear Cover.
8. Do REP 1.1 Top Cover Replacement
9. Connect the Power Cord
10. Turn ON the eWire.
01/26/2018
4-37
to replace the Top Cover.
Repairs/Adjustments