Rep 1.8 Front Cover Replacement - GBC eWire Service Manual

Installation Procedure
1. Place the Book Tray Door in position so the M4 holes on the upper
and lower mounting holes are aligned with the corresponding screw
holes on the Book Drawer. Tighten the M4 Screws (4) to secure the
Book Tray Door.
2. Tighten the M4 Screws (3) to secure the left side cover plate.
3. Tighten the M4 Screws (3) to secure the right side cover plate.
4. Do ADJ 1.7 to adjust the Interlock Flag.
5. Plug in the Power Cord.
6. Switch power ON to the eWire
Repairs/Adjustments

REP 1.8 Front Cover Replacement

PARTS LIST ON PL 5.28
Use this procedure to remove and install the Front Cover.
Removal Procedure
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Raise the Upper Transport Assembly by releasing the latch on the
Top Cover.
4. Loosen, but do not remove completely the M4 Screws (2) on the side
of the Front Cover.
01/26/2018
4-10
GBC eWire