GBC eWire Service Manual page 203

6. Loosen the set screw securing the Cam to the Shaft.
7. Slide the Cam and Washers off the shaft.
GBC eWire
Installation Procedure
1. Slide the Washer and the new Cam onto the Shaft.
2. Install the Retaining Ring on the end of the Shaft
3. Tighten the Set Screw to secure the Cam to the shaft.
4. Repeat the procedure for the opposite Cam.
5. Do REP 3.15 Element Transfer Module Replacement
Element Transfer Module.
6. Connect the Power Cord.
7. Power ON the eWire.
01/26/2018
4-87
to install the
Repairs/Adjustments