Rep 3.9 Spool Rewind Drive Assembly Replacement, M8 - GBC eWire Service Manual

REP 3.9 Spool Rewind Drive Assembly Replacement, M8

PARTS LIST ON PL 5.8
Use this procedure to remove and install the Spool Rewind Drive
Assembly. The Spool Rewind Motor (M8) and Spool Rewind Belt are
included as part of this assembly.
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
Removal Procedure
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Open the Front Door and slide out the Element Feeder drawer.
4. Do GP 6.8 to remove the Supply Spool.
5. Remove the Element Feeder Rear Cover by removing the M4 Screws
(8). The bottom screws can be used as a pivot to aid removal.
GBC eWire
6. Loosen the M4 Screws on the Belt Tensioner and slide the Tensioner
forward to relieve tension on the Spool Rewind Belt.
7. Slide the Belt off of the Drive Pulley.
01/26/2018
4-61
Repairs/Adjustments